“I just finished repairing an Ice Castle fish house, and in my mind, it’s a worst buy. A cable winch on each wheel mechanism raises and lowers the house, but the owner said the winch mechanism on one side didn’t work. Before he had it, it served as a warming house on a construction site.
“If I’d known what I was getting into, I’m not sure I would’ve taken on the job. When I set it up on blocks and removed the wheel, I could see the problem. The wheel mechanisms were designed to pivot on 2-in. shafts welded through and to the ice house frame. On the problem side, the shaft had ripped right off the frame.
“It ripped free because the shaft had rusted solid to the pivot point on the wheel mechanism arm. When the owner attempted to lower the wheel, the winch ripped the shaft out and even broke the reinforcement gusset on the other side of the frame. The 1/8-in. steel tubing simply wasn’t strong enough to hold it.
“I cut the shaft off at the frame with a Sawzall to free the pivot point arm so I could work on it. I couldn’t use a press to push the shaft out because the pipe housing at the pivot point arm was too weak. It took repeated heating of the shaft housing with a torch for short periods of time and lots of penetrating oil to pound out the shaft. I couldn’t heat it too much or the shaft would expand.
“Once it was out, I used 4-in. long, 1/4-in. thick flat iron to reinforce the frame the new shaft would be welded to. Given the proximity to the wooden floor of the icehouse, I punched five 3/4-in. holes along the top edge for welds, then did the bottom with regular welds.
“I replaced the 2-in. shaft with a 1 3/4-in. shaft and slipped brass bushings with that inside diameter and a 2-in. outside diameter into each side of the pivot point. I tapped holes for grease zerks in the bushings and drilled access holes in the pivot point arm so the shaft could be lubricated. It was steel-on-steel that caused the problem.
“With the new shaft and bushings in place, I reinstalled the wheel mechanism and the wheel. Everything worked fine because the winch and wheel mechanism were well-engineered. The frame tubing, however, was just too weak.”