Cummins diesel engines
What FARM SHOW readers say · 4 Best Buys2 Worst Buys · Trucks & Cars
Cummins diesel engines
4 Best Buys2 Worst Buys“I’ve used Schaeffer’s Moly Bond X200 15W-40 engine oil since 1987 in all my diesel pickups (www.schaefferoil.com; ph 800 325-9962). This premium quality, multi-grade, heavy-duty engine oil is specially formulated to extend engine life. I own five different 1995-1996 Dodge 1-ton diesel pickups and I change the oil on all of them only about every 10,000 miles. The pickups have from 100,000 to 350,000 miles on them, but I’ve never had to drop an oil pan or pull a fuel injection pump. Moly Bond oil and the 12-valve Cummins diesel engines that power these pickups are both best buys.”
“Over the years I’ve owned several Cummins diesel engines including two 5.9L’s, a 6.7L, an 88 NT, and an 8.3L. These engines are dependable, start in cold weather, and have plenty of power and torque. I have them in my Dodge 2500 pickups, a Ford 9000 tandem axle flatbed truck, and Kenworth 300 tandem axle trucks. The engines’ inline design makes them easy to service, and they’re reasonably fuel efficient. The 88NT and 8.3L have almost 1 million miles on them but are still going strong.
“I use my 2013 Branson 3720 forklift in our apple orchards. This forklift offers a low cost alternative to rough terrain forklifts that sell for $60,000 to $70,000, but its design and engineering leave a lot to be desired. The 3-speed transmission doesn’t have enough gears and should be upgraded to a 4-speed. The forklift had some hydraulic leaks that I finally solved. Shortly after I got it, a steering arm casting broke and the steering arm had to be replaced. Another problem is the transmission creeps unless I use the brakes or tap the shuttle, which is a safety hazard.
“On the plus side, the forklift’s diesel engine runs good and starts easy in cold weather. The machine has a short turning radius, and its 2,500-lb. mast can handle a tank of cherries or 2 bins of apples with no problems. However, dealers don’t seem to stock a lot of parts and as a result I’ve had to wait several days for parts.”
“My best buy ever was my 1981 Bobcat skid steer loader. I used it to load silage every day of the year and also to load all the manure from our farm. In 1998 I traded it in for a new Bobcat 773. No problems with either machine.
“The Cummins irrigation engine that I bought new in 2000 is my worst buy. It was hard to start, due to a bad starter. Then the push button starter switch kept falling off due to vibration. The exhaust pipe also vibrated off.”
“We installed a 5.9-liter Cummins diesel engine in our 1992 Ford F-250 4-WD Supercab pickup and it really worked out great. This repower job was such a success that we put the same engine in a 1988 Ford F-250 4-WD pickup. Both vehicles have performed great since the conversions, both in fuel economy and power.”
“My worst buy is the 1997 Cummins diesel engine in our Gleaner R52 combine. It has 180 hours on it. The problem is that it leaks oil -I scooped several shovels full of greasy dirt out of the engine compartment. The dirt even gets into the combine’s cleaning shoe. There’s a puddle of oil at the blowby pipe, too. I don’t know how this problem will be resolved. It’s still under warranty.”
“It’s the best pickup I’ve ever owned,” says Ronald about his 1989 Dodge 250 4-WD pickup equipped with a Cummins diesel engine and 5-speed manual transmission. “I put 20,000 to 25,000 miles on it every year, but it still has the same power and fuel economy that it had when it was new and doesn’t use even a quart of oil between changes. I usually change oil every 4,000 to 5,000 miles. I use it to haul livestock, hay, equipment, etc. It rides a little rough but I expected that with a heavy duty pickup. I do wish that it had an extended cab. When I decide to trade it in I’ll probably buy another Dodge.”
Own a Cummins? Tell FARM SHOW how it’s held up.
Your report could appear in a future issue.